×

How to Texture Walls With the Knockdown Technique

A textured finish applied to dry walls is referred to as knockdown texture. This name refers to the process of applying the compound on the wall and then knocking the excess off to create a textured wall surface. One benefit to having knockdown-textured walls is that the treatment hides imperfections on the walls.

Things You Will Need

  • Drywall tape
  • Level
  • Dropcloth
  • Spray gun
  • All-purpose joint compound
  • 5-gallon bucket
  • Power drill with mixing hook
  • Air compressor
  • Scrap lumber board
  • 12-inch taping knife

A textured finish applied to dry walls is referred to as knockdown texture.  This name refers to the process of applying the compound on the wall and then knocking the excess off to create a textured wall surface. One benefit to having knockdown-textured walls is that the treatment hides imperfections on the walls. 

  1. Prepare the walls by taping the drywall seams with drywall tape. Use a level to ensure all walls are level and flush. Lay a dropcloth under the wall where you are applying the knockdown texture. The dropcloth will protect the floor from fallen debris.
  2. Read the directions for the spray gun to find the water ratio for the all-purpose joint compound and the pressure recommendations.
  3. Prepare the all-purpose joint compound in a 5-gallon bucket according to package directions. Add the amount of water into the bucket of joint compound as recommended in the spray gun directions. Mix the water into the joint compound with a mixing hook attached to a power drill.
  4. Turn the air compressor on, and set the spray gun pressure according to its directions.
  5. Stand a scrap lumber board against one wall. Fill the spray gun's hopper with the thinned joint compound. Use the spray gun to spray onto the piece of scrap lumber board. Make adjustments to the spray gun as needed to create the desired knockdown pattern.
  6. Begin spraying the joint compound onto the drywall at the top, holding the spray gun at least 12 inches away from the wall. Continue applying the knockdown texture one wall at a time. Allow the joint compound to dry on the wall for at least 20 minutes.
  7. Hold a 12-inch taping knife against the sprayed wall, starting at the top and tilting the edge of the taping knife at a very low or 5-degree angle. Pull the taping blade down to the ground, applying light pressure. Move the taping knife 10 inches over and continue to knock down the joint compound off the wall.
  8. Tip

    If you have an accidental overspray of joint compound, use the taping knife to scrape the excess off the wall before the compound sets up.

Things You Will Need

  • Drywall tape
  • Level
  • Dropcloth
  • Spray gun
  • All-purpose joint compound
  • 5-gallon bucket
  • Power drill with mixing hook
  • Air compressor
  • Scrap lumber board
  • 12-inch taping knife

Tip

  • If you have an accidental overspray of joint compound, use the taping knife to scrape the excess off the wall before the compound sets up.

About the Author

Rachel Turner has been writing professionally since 2000, focusing on gardening and home improvement topics. Her articles have appeared online at SlowTravel and in publications such as the "Arkansas Gardeners," "One Step Ahead" and "Writers Now." Turner holds a Bachelor of Arts in English from Arkansas State University.

Photo Credits

  • Jupiterimages/Pixland/Getty Images
  • Jupiterimages/Pixland/Getty Images