How to Upholster Benches With Foam Padding & Vinyl Fabric

If you have benches with seats too hard to sit on comfortably for long periods, then consider upholstering a foam cushion using vinyl fabric tailored for your bench.

Instructions

Vinyl is a versatile fabric that is stain-resistant and easy to keep clean---just use household cleaner and a sponge. This project is especially suited to benches around a kitchen or dining room table, because the cushions are easy-to-clean yet attractive and comfortable. This is an easy, no-sew project, which doesn't take long, but results in a custom cushion so you can relax with a hot fudge sundae without worrying about spills.

Measure the length and width of your bench seat and purchase foam in that size. If the fabric or craft store doesn't carry foam in your specific size, buy the next largest size and cut at home using an electric kitchen knife or ask a clerk at the fabric store to cut it for you. Give yourself an extra half yard of vinyl fabric: You can cut excess off but can't add it back on. Purchase enough iron-on hook-and-loop fastener (Velcro) to run the length of the cushion, plus an extra half yard for the sides.

Spread your vinyl fabric out on a flat surface, right-side down, and smooth out any wrinkles. Center your foam pad on the wrong side of the fabric. Wrap the fabric length-wise, like wrapping a gift, to make sure the fabric covers well. Then, pin the Velcro on one side, just to the length of the vinyl that will wrap around the foam; do not extend past the edge.

Once the first length of Velcro is pinned, follow the instructions for iron-on Velcro, and attach. Once it's attached, fold it back over the foam and mark on the opposite length of fabric where the other strip of Velcro should be ironed on to create a snug fit. Attach the Velcro, again making sure not to extend past the edge. Connect the fabric, making sure it's a tight fit.

Fold one end like you would when wrapping a birthday gift. Fold the top piece of fabric down, trim any excess so the fabric stops about an inch from the bottom of the foam. Secure by sticking a few pins through the fabric bottom into the foam. Next, fold in the two sides and secure with pins. Now, before folding the final piece up, cut a length of Velcro and pin about a half inch below the top edge. Iron on. Then, mark where the other length should go for a tight fit and attach. Repeat on the other side.

If the ends seem a bit loose, you can attach another piece of Velcro to secure any gaps, but if you pulled tight enough when folding, your Velcro should hold. Now, all you have to do is turn it over, place it on the bench, and enjoy.

Things You Will Need

  • 2- to 3-inch foam padding Electric kitchen knife Vinyl fabric Iron-on hook-and-loop fastener (Velcro) Iron and ironing board Pins

Tip

  • When choosing your vinyl fabric, take any paint samples, fabric swatches or throw pillows from the room your bench resides in so you choose an appropriate color or pattern. When choosing your foam thickness, think about what type of bench you have and who sits on it the most. Then, choose the appropriate thickness for your comfort. If you go thicker than 3 inches, buy more fabric to compensate. Velcro makes it easy to take the cover off if you need to change it.

About the Author

Tonya Goodspeed has written professionally since 2003 and specializes in articles on travel, weddings, invitations and home and garden topics. She also ghostwrites Web and blog content. She earned an English degree with a minor in French from the University of Virginia.