Can You Root Pecan Trees From Cuttings?

Best Type of Cutting

Two types of cuttings can be taken from pecan trees for rooting: softwood or hardwood cuttings. According to the USDA Forestry Service in their manual on hardwoods, "Silvics Manual Volume 2," from the chapter “Pecan,” softwood cuttings are easier to root. Putting the cuttings into the soil mix for rooting is called “sticking.”

Softwood cuttings are best taken in late spring or early summer from new growth. Test to see if you have true softwood. According to Miranda Smith in her 2007 book, “The Plant Propagator’s Bible,” bending branches at a 90-degree angle, 6 inches from the tip, will tell you whether you have softwood. “Hardwood won’t bend at all, and branches that are too young to cut won’t break.”

Taking Cuttings

The two most important factors in rooting are noting when you take cuttings and the age of the tree. Shoots from young trees root better because the parents are still in a vigorous growth stage. Avoid shoots with flower buds when taking cuttings or remove the buds before sticking the cuttings.

Softwood cuttings are best gathered in the morning. Take cuttings just before you plan to use them and carry a bucket or can with wet paper towels in it to keep the cuttings cool and moist. Make sure your container has a cover to exclude light. Cut 6 inch sections from stems that have stopped growing at the tips but haven’t hardened completely yet. Make your 45 degree cut 1 inch below the spot where a leaf joins the stem. Remove all but the top two leaves from the cuttings and roll them up gently in your wet paper toweling.

Sticking Cuttings

Stick cuttings immediately after you take them. Have rooting trays filled with a moist, sterile commercial rooting mix ready and use rooting hormone. Cuttings can be wounded on the bottom 4 inches by removing small patches of the outer bark to allow rooting hormone to enter. After dipping the bottom 4 inches of the cutting in rooting hormone, tap off the excess and insert it in the rooting mix till only the top 2 inches protrude.

Softwood cuttings need at least six hours of light per day to root, but not direct sunlight. Propagation beds with grow lights, timers and heaters can be purchased from many sources. The ideal rooting tray has a heated bed (usually set to 70 degrees) and a vented cover. Moisture loss in the rooting mix is the primary cause of failed cuttings. Misting run by a timer reduces water loss through leaves and increases rooting success.