×
x

Removing Wooden Decks

Any wood used around the exterior of your home will deteriorate over time. It may be come necessary to remove and replace lumber especially if it has ground contact. A exterior deck is a good example of this.

Removing wooden decks

Things You Will Need

  • Power screwdriver with bits
  • Circular saw
  • Tape measure
  • Chalk line
  • Reciprocating saw with wood blade
  • QuickRip demo tool
  • Shovel
  • Socket wrench with sockets
  • Work gloves
  • Safety glasses

Any wood used around the exterior of your home will deteriorate over time.  It may be come necessary to remove and replace lumber especially if it has ground contact.

A exterior deck is a good example of this.  The decking boards and the post can crack and split over time making the deck a safety hazard the needs to be taken care of.

The do it yourself handyman can tear down and dismantle a deck with the help of a few friends. 

  1. Examine the deck to decide if there is any part of the deck that you may want to try and save and reuse. If this is the case you may need to modify some of the steps in order to save them.
  2. Remove the decking boards. Depending on the condition of the deck you can use a power screwdriver with a new bit to remove the existing screws from the decking boards. If this is not the case skip to the next step.
  3. Set the depth of cut on a circular saw to 1/2-inch deeper than the decking material. Snap a chalk line between every other floor joist. Use the circular saw to cut along the line to make it safer and easier to remove small sections of the decking at a time. To finish the cut close to the house where the circular saw can not reach, use a reciprocating saw with a wood cutting blade.
  4. Use the reciprocating saw to cut the floor joist’s off from the rim joist. Cut them off a couple of inches from the joist hangers. You will need some help holding them still as you cut them off at both ends.
  5. Remove the post from under the old deck. These will either be set into the concrete or attached with a post hanger. Dig out the post with a shovel and remove them.
  6. Remove the rim joist from the post and the house. Use the reciprocating saw to cut them from the post. This will work for all of the rim joist not attached to the house. Use a socket wrench and socket to remove the lag bolts that attach the rim joist to the surface of the house.
  7. Tip

    This task will require more than one person at times of lifting heavy boards.

    Warning

    Beware of rusted nails and other debris. When lifting heavy objects bend at the knees, back support is also a safe idea. Only walk on the decking area that is between the floor joist that are not cut through. Wear safety glasses and gloves when tearing down the deck

Things You Will Need

  • Power screwdriver with bits
  • Circular saw
  • Tape measure
  • Chalk line
  • Reciprocating saw with wood blade
  • QuickRip demo tool
  • Shovel
  • Socket wrench with sockets
  • Work gloves
  • Safety glasses

Tip

  • This task will require more than one person at times of lifting heavy boards.

Warnings

  • Beware of rusted nails and other debris. When lifting heavy objects bend at the knees, back support is also a safe idea.
  • Only walk on the decking area that is between the floor joist that are not cut through.
  • Wear safety glasses and gloves when tearing down the deck

About the Author

Jim Wildman served in the United States Marine Corps as a Communication Chief for 10 years. After his tour of duty in Desert Storm he attended Oklahoma State University receiving his Bachelor of Architecture. He worked as an architect for 10 years before starting his own design/build company. He began writing in 2009 for Demand Studios and published on eHow.

Photo Credits

  • deck image by Albert Lozano from Fotolia.com
  • deck image by Albert Lozano from Fotolia.com