Maytag Quiet Series 300 Instructions

You simply insert the dishes and select the desired cleaning cycle you want. Operating instructions are provided in your user manual but there are some general instructions that every Maytag Quiet Series 300 owner should know before their first use.

1. Scrape off any bones or large food particles from the dirty dishes. Load your dirty dishes into the Maytag Quiet Series 300 at angles that maximize the space and face dirty services toward the center of the dishwasher.

2. Add the detergent to the holders located in the front of the unit. Close the dishwasher door and latch it. Press the pads on the control panel to select the cycle you want to use. Press the START/Cancel pad on the control panel to start the dishwashing cycle.

3. Listen for the chime indicating the wash cycle is over. Unlatch the door and open it. Remove the now clean dishes as soon as possible from the dishwasher to any rusting of the dishes. Remove any debris from the bottom of the dishwasher that may have collected from the dishes.

Tip

Extended interruption during the cycle is not recommended but if you have to add a dish at the last minute, unlatch the dishwasher door and wait for the water circulation to stop. Open the door and add the dish. Close the door and latch it. Verify that the red interruption lights stop flashing. The cycle will automatically start within thirty seconds.

Warning

Do not try to clean non-dishwasher safe dishes in your Quiet Series 300 to avoid damage to the dishes or the dishwasher.

Avoid blocking the spray arms with your dishes because it will make it reduces the cleaning efficiency of your dishwasher.

Dishes may be hot directly after the clean cycle. Avoid injury from the hot dishes or the steam by using protective gear or waiting a few moments until the dishwasher cools off.