How to Cut Vertical Blinds

Vertical blinds for windows typically come in a standard length of 84 inches. Some manufacturers and distributors will custom cut your new vertical blinds, but often for an additional fee.

Low ceiling height, the installation of an exceptionally thick carpet, or the installation of a new floor over top an existing floor are all reasons why a length shorter than standard may be required for your vertical blinds. You may wish to trim a set of existing blinds when relocating them from one window to another. The basic technique for cutting vertical blinds varies only slightly according to the material with which they are made.

Fabric Blinds (No Vinyl Backing)

  1. Remove vertical blinds from rod and lay on bare floor or other suitably long, flat surface.

  2. Remove weights from bottom of fabric louvers and set aside.

  3. Measure each louver lengthwise and mark with pencil. Allow enough extra length to fold and re-sew the weight pocket (approximately 2 1/8 inches extra).

  4. Cut each louver individually with scissors and straight edge where marked.

  5. Fold each louver under, and sew to create weight pocket.

Vinyl, Perforated Vinyl, Metal or Vinyl-Backed Fabric Blinds

  1. Put vertical blinds on a flat surface.

  2. Measure each louver for desired length. Mark with pencil.

  3. Cut each louver using scissors and straight edge.

  4. Sand louvers with minimal pressure to eliminate rough edges. Start with fine grit and end with superfine grit sandpaper.

Faux Wood or Wood Blinds

  1. Lay vertical blinds on a flat surface.

  2. Measure louvers and mark with pencil for cutting.

  3. Cut each louver individually with chop saw.

  4. Sand bottom edge of each louver, beginning with fine grit sandpaper and ending with superfine grit. Use only enough pressure to sand away rough or uneven edges.