Open the faceplate on the Hunter thermostat.
Twist a paper clip so one of the ends is sticking out.
Press the end of the paper clip into the "Reset" pinhole and hold it for two seconds to clear the programming. The location of the hole varies depending on the model, but it is usually located near the bottom or side of the front panel and is clearly marked.
Mandy Slake has been writing since 2000. She authors technical documentation for the wireless and software industry. Slake studied computer science at Highline Community College in Midway, Wash. She has over nine years of experience in the…
HomeSteady is the ultimate guide for all your household needs, from cleaning and HVAC to electrical, DIY and maintenance.
Property of TechnologyAdvice. © 2026 TechnologyAdvice. All Rights Reserved
Advertiser Disclosure: Some of the products that appear on this site are from companies from which TechnologyAdvice receives compensation. This compensation may impact how and where products appear on this site including, for example, the order in which they appear. TechnologyAdvice does not include all companies or all types of products available in the marketplace.
