×

How to Remove Mold From a Door Gasket

Stevie Kremer

High humidity can create conditions that are perfect for mold growth. Mold is not only unsightly and can present health hazards, but it can also stain surfaces. Unfortunately, one such place for mold growth is on the surface and in the folds of rubber gaskets that provide a tight seal around doors, especially refrigerator and freezer doors. It is not difficult to clean the gaskets, but it is important to use solutions that will kill the quick-growing mold.

How to Remove Mold From a Door Gasket

Step 1

Place a large plastic garbage bag on the floor in front of the refrigerator or freezer door to protect the floor from drips. Put on rubber gloves; measure 1 cup of bleach and pour it into a bucket containing 1 gallon of water.

Step 2

Dip a clean rag into the bleach solution, wring out the rag and wipe it over the moldy gasket. Repeat at least three times, and then allow the solution to soak on the gasket for about 10 minutes.

Step 3

Dip a clean, soft-bristled toothbrush into the solution and scrub the crevices of the gasket to remove all traces of mold.

Step 4

Wet a clean rag in some clean water and wipe down the gasket to rinse off the bleach solution. Dry the gasket thoroughly with a dry paper towel.

Step 5

Mix a solution of 1 cup of white vinegar with 1 cup of water and put it into a jar with a tight-fitting lid. Dip a clean rag into the jar, wipe down the gasket and rinse it every week to prevent the mold from returning. If the mold does return, repeat the bleach solution treatment.