As NICAD rechargeable batteries are used and recharged, crystals build up within the battery, blocking the ability of the battery to hold a charge. Resetting the memory in NICAD batteries is a process in which NICAD rechargeable batteries are “jumped” like a car battery to remove the crystal buildup, allowing the battery to work like new.
Things You Will Need
-
Test the NICAD batteries using the battery tester to determine whether the NICAD batteries are fully discharged.
-
Locate the negative and positive nodes on the NICAD rechargeable battery. The negative node is on the flat end and the positive node is on the raised, bumpy end of the battery.
-
Put on all recommended safety gear.
-
Attach and hold the black clamp from the 12-volt battery charger to the negative end of the NICAD battery.
-
Rap the positive end of the battery with the red clamp from the 12-volt battery charger. This may cause the battery to emit sparks. It is part of the process of resetting the NICAD battery's memory.
-
Hold both the black and the red clamps on the appropriate negative and positive ends, respectively, of the NICAD battery for 1 to 3 seconds maximum. Release both clamps.
-
Retest the NICAD battery with the battery tester to determine whether the NICAD battery's memory has been fully reset.
-
Repeat the NICAD battery resetting process if necessary.
The Drip Cap
- Resetting the memory in a NICAD battery will revive dead rechargeable NICAD batteries.
- Locate the negative and positive nodes on the NICAD rechargeable battery.
- Attach and hold the black clamp from the 12-volt battery charger to the negative end of the NICAD battery.
- Retest the NICAD battery with the battery tester to determine whether the NICAD battery's memory has been fully reset.